WCDMA RAN Systems and Site Introduction. RBS components. WCDMA RBS Maintenance. 2. Customer Product Information (CPI) and. TXO Systems has the ERICSSON RBS RRUS 12 B3 in stock, along with a wide range of used and refurbished telecommunications equipment from all. Ericsson shall have no liability for any error or damage of any kind resulting from The support system for the RBS main unit is available in two variants.
|Published (Last):||9 December 2008|
|PDF File Size:||10.3 Mb|
|ePub File Size:||15.57 Mb|
|Price:||Free* [*Free Regsitration Required]|
See all electronauts has no other items for sale. The connector is keyed so that only one end fits into port SAU on the support system. To connect the RBS to the twisted-pair cable: Next-day delivery and time-slot delivery may be available upon request, but these services are subject to delivery address and will usually incur a charge.
The cable connecting the two support systems is 1 m long to allow the removal of the support systems from the rack for service purposes without disconnecting the cables.
Fasten the two screws on the TCU board front. To unpack and check the materials, do the following: Image not available Photos not available for this variation. Slot 2 is the upper position in the main unit. More information on cabling can be found in Non-RF Connections.
Ericsson RBS 6601 LTE Indoor Main Unit Remote Base Station 1/bfl 901 009/4
Detailed information is found in Hardware Maintenance Instructions. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document.
Place rba main unit in the rack. Remove the dummy board in slot 2, if there ericssoon one. Do not twist the fiber to the minimum bending radius. Each alarm signal ericssoon of one pair of wire connections. Handle the optical cables with care and do not exceed the minimum bending radius, see the manufacturer’s specification.
Connect the longer Enclosure Control EC bus cable as follows: You are free to manage this via your browser settings at any time. For instructions on how to connect the optical cable to a bidirectional transceiver SFP, see Section To remove a wire from the connector, push the corresponding release tab on the connector with a small screwdriver and carefully pull the wire. Reinsert and tighten the hexagon screw to a torque of 15 Nm using a torque wrench and a 13 mm socket.
Lock all doors and gates to the site. Report any faults according to local requirements. To install a TCU in slot 2 in the main unit: Remember me on this computer.
Learn More – opens in a new window or tab International shipping and import charges paid to Pitney Bowes Inc. Check if the main unit has the standard brackets installed for inch rack.
Ericsson Rbs , Ericsson Rbs Suppliers and Manufacturers at
See other items More Resume making your offerif the page does ericwson update immediately. Mouse over to Zoom – Click to enlarge. Delivery times are as follows: To adjust the main unit using standard brackets: See Figure 5, letter B.
Seller does not offer returns. Enter the email address you signed up with and we’ll email you a reset link. Learn more – opens in a new window or tab. Optical indicators show the board status. Each support system provides power to its hosted DU.